ENEXT

The single-phase electronic electricity meter e.control.w07 is designed for accurate measurement of active electricity in single-phase networks. It is distinguished by a wide measurement range (from 5A to 65A), high accuracy class and multiple control and reporting functions. Suitable for residential, commercial and administrative facilities.

Current transformer e.trans.600.split 600/5A class 1.0 with separable magnetic conductor is designed for control and transmission of measurement information signal to means of measurement, reading, protection, automation and control in alternating current networks.

The e.is3.pro.4.63, 4p, 63A three-position DIN-rail switch is designed for switching electrical circuits, switching phases, reversing motors, manual reserve switching, etc. The product is used in networks protected against short-circuit and overload currents.

Contactor e.industrial.ukc.85.110, 85A, 110V, 1NO+1NC Intended for use in stationary installations for remote starting, stopping and reversing by direct connection to the network of 3-phase asynchronous electric motors with a squirrel-cage rotor, as well as for switching circuits for group lighting and other low-inductive loads.

The E.STAND ATS 2.63 automatic transfer switch (ATS) is designed for automatic and manual switching between the main and backup power supply in low-voltage electrical installations with a rated current of up to 63 A. It provides reliable power supply management, reducing the risk of interruption of critical consumers in the event of a main power failure. The design is modular with 35 mm DIN rail mounting, which facilitates installation in panels and distribution systems.

The E.PRO UKC 4.95.400 contactor is an electromagnetic switching device from the E.PRO series of E.NEXT, designed for controlling, switching on, switching off and reversing AC electrical circuits via remote control. It is suitable for use in stationary low-voltage installations for controlling 3-phase asynchronous electric motors, group lighting and other low-inductive loads. It has three main poles and two additional contacts (1NO + 1NC), which allow for extended functionality and integration with control circuits.

The e.tool.crimp.hx.120.b.10.120 tool for crimping cable lugs 10-120 sq.mm is designed for crimping copper and aluminum non-insulated cable lugs. The design allows you to select the desired cross-section for the crimping tip by rotating the die. Compression shape: hexagonal. Not intended for use with steel bushings and ferrules.

The e.industrial.ukc.65.24, 65A, 24V, 3P, 1no+1nc contactor is intended for use in stationary installations for remote starting, stopping and reversing by direct connection to the mains of 3-phase short-circuited induction motors, as well as for switching circuits of group lighting and other low inductive loads.